Before & After Photos

This customer in Bloomfield, CT called us hoping that we would be able to help her replace her old bulkhead door. It was quite old and very rusty, and she wanted a new one that looked better.

Luckily, Fogarty's Home Services was able to help this customer. We were able to install a beautiful new bulkhead door. We caulked around the edges and installed flashing behind the door to ensure a tight fit.  Now, this homeowner has a new, beautiful bulkhead door that will look nice for years to come! 

This homeowner called our office looking for a full Energy Evaluation because her home was very cold and drafty and very expensive to heat. 

Upon performing the evaluation, our Building Science Specialist realized that the basement was the main culprit. Without a properly insulated and air sealed basement, your home may seem much colder than necessary, resulting in a cold and drafty home overall and much higher energy bills! 

By Insulating the Rim Joists with Closed Cell Spray Foam and lining the basement walls with Foamax Insulation Board, Dr. Energy Saver was able to fix the problem and accomplish our goal to provide warmer, less drafty rooms, and lower energy costs, making this homeowner happy, and more comfortable.

This homeowner in Bloomfield, CT called us looking to have his attic insulation replaced. When our Home Comfort Specialist arrived at the home, he noted that this customer had large fiberglass batts for insulation. The insulation was dirty, covered in rodent droppings, and was in desperate need of replacement. It was obvious that there was an air leak of some kind in this attic due to the dirt that was strewn across the insulation.

We were able to help this customer with a short process. First, we removed the fiberglass batts that were in his attic. We then went in and air sealed in all of the tight spaces of the home -- between boards, in joints, et cetera. We then installed our TruSoft™ cellulose insulation in the attic. This insulation is blown in with a large machine. Since it is blown in, it is able to rest in all of the hard-to-reach nooks and crannies - making sure that there are no spots left uninsulated. 

This will drastically help the temperature of the home as well as keep the homeowner's energy bills down for years to come! 

This homeowner in Bloomfield, CT called us hoping that we would be able to help her with her basement insulation. She had old insulation she needed to have replaced, as she had a rodent issue and high humidity in her basement. In a basement, the “rim joist” is the perimeter of the floor framing system along the exterior of the house. The joints and gaps between all the framing members allow for a lot of air leakage into the house. The rim joist is seldom insulated and never air sealed. Basement ceiling insulation, especially fiberglass batts, doesn’t stop the flow of cold air into the home. Results - cold floors, drafty, uncomfortable rooms, cold basement/lower level, higher heating and cooling bills and more condensation in the basement or crawl space in the summer.

We had the perfect solution for this customer! In this solution, we spray foam the rim joist in the basement in order to seal and insulate it. Two part expanding spray foam is installed on the rim joist and over the sill plate to seal all air leaks from the outside and insulate this important area of the home. Our spray foam has a high insulation value per inch of R7, and because it expands, it seals all cracks and gaps and joints where air from the outside enters the home. Results - warmer floors, less drafts, more comfortable rooms, the house is easier to heat and costs less to heat, less summertime condensation on cold basement surfaces.

These home owners in Drury, MA had problems with cold floor and a freezing basement. A quick check of the basement and we found out that the rim joist wasn't insulated. Insulating a rim joist is one of the most important thing you can do to help make your home more comfortable. To stop the air from coming in and the cold from conducting through the wood, our team sprayed the rim joist and sill plate with our 2-part closed cell spray foam. This treatment will stop the cold air from getting through the cracks and will stop the cold from conducting through the wood and getting into your home. Once this is done, you will not have to worry about cold floors and a cold basement again!